XV250 Virago Regulator

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

Bob Dodds - 08 Dec 2007 07:39 GMT

Can anyone tell me where the voltage rectifier/regulator mounts to a 1996
XV250 Virago. I've just replaced a burnt out harness so the whole bike was
in bits when I bought it and a complete rebuild is ongoing.. I've got the
manual but it isn't that clear where it fits. An XV125 would probably be
similar as I'm finding most parts are interchangable.

Thanks

Bob

Reply to this Message

Albrecht - 09 Dec 2007 03:01 GMT

>Can anyone tell me where the voltage rectifier/regulator mounts to a 1996
>XV250 Virago. I've just replaced a burnt out harness so the whole bike was
>in bits when I bought it and a complete rebuild is ongoing.. I've got the
>manual but it isn't that clear where it fits. An XV125 would probably be
>similar as I'm finding most parts are interchangable.

http://webservices.motorsportdealers.com/parts/partImages/YAM/3/02/0150/0039.Gif

Item #9 is the rectifier regulator.

Reply to this Message

Bob Dodds - 09 Dec 2007 13:22 GMT

Thanks that helps, but there is no mounting point where the picture shows
somewhere under the battery box. To the right side is the indicator and
control relay mounts and the rear is the igniter mounting bracket. On the
left side under the the side panel is a possibility but then it would be out
of any air flow and get no cooling, so I'm not sure if that's the right
place.

Regards

Bob

>>Can anyone tell me where the voltage rectifier/regulator mounts to a 1996
>>XV250 Virago. I've just replaced a burnt out harness so the whole bike was
[quoted text clipped - 5 lines]
>
> Item #9 is the rectifier regulator.

Reply to this Message

Motorcycle Forum / General / Yamaha / December 2007

XV250 Virago Regulator